Serpent – May New Product

803199.jpg

Chassis 4mm 720 LCG

Machined low center of gravity chassis plate for the Serpent 720.

New for the Serpent 720 is this new optional chassis plate which has been heavily milled on the topside to enable the whole car to sit lower, allowing for a lower centre of gravity while, through the addition of extra holes, the chassis plate is now extremely light. This chassis will be perfect for those racers looking for that extra cornering advantage in higher grip conditions and to allow your chassis to be made stiffer, the front of the chassis has space to mount the optional carbon stiffener plate, which will be sold separately.

Servo Saver Spring HARD
803203.jpg

New harder servo saver spring for use with the Serpent 710 and 720.

Spring Cup Nylon ISL
903240.jpg

Set of 4 spring cups for Serpent shock absorbers that raises the spring height on the shaft by 2mm.

New from Serpent for use with RCC shock absorbers, and other Serpent shock absorbers, are these new optional nylon spring cups. Coming in a pack of 4 the new supports sit 2mm higher on the shock shaft meaning that you have a wider range of spring tension adjustment than with the standard versions. The new spring cups also provide extra strength when using harder springs due to the new thicker design, which prevents the shock ball-end being pushed through the support in the event of an impact.

Rod Set 16mm/Ball Joint
803200.jpg

Upper rear short track rod set for the Serpent 720, that contains 4 ball joints and 2 short track rods.

For use with the Serpent 720, these new track rods are ultra short to enable you to use the shortest upper track rod pivot hole on the new optional GTP suspension support plate (#803182). Using shorter composite ball joints the set also features new short track rods, which can be easily adjusted thanks to the square nut on the rod, allowing you to adjust the length while the track rods are still mounted.

Spring Support Alu Light
903232.jpg

Set of 4 lightweight aluminium spring supports for Serpent shock absorbers.

New from Serpent for use with RCC shock absorbers, and other Serpent shock absorbers, are these cool new optional spring supports. Coming in a pack of 4 the new supports are made from lightweight and strong aluminium and have been lightened further through the addition of holes in each piece. Offering extra strength when using harder springs, the use of this new material prevents the shock ball-end being pushed through the support in the event of an impact.

Source : Serpent

This entry was posted in Serpent. Bookmark the permalink.