Tamiya – XB Mazda RX-7

57766top.jpg

With TT01D Chassis and will available in July 14, 2007

Translation :

< With drift travelling + light/write illumination charm redoubling of running >They are 1/10 scale completion electromotive radio control cars of Matsuda RX-7 which gains even now high popularity as the pure sport car which loads the rotary engine. Reproducing the forum which consists of the dynamic curved surface to real with polycarbonate. In addition, LED of white, building in LED of the lead-lead to the rear combination lamp in the headlight which popup is done. Approximately illumination of the light/write engenders more reality in running. Furthermore, like name being able to enjoy drift travelling easily charm. The body also the transmitter assembly and wheel type, the battery and the charger for travelling are set the paint and can enjoy running directly.

57766photo1.jpg

Setting LED inside the resin make headlight case. The white light which represents HID is charm.

57766photo3.jpg

Rear combination lamp case resin make. Installing red LED, usual it lights up.

< Adoption private chassis> The RC mechanic and the battery for travelling were loaded onto flat in the mainframe of bathtub type, low shaft drive 4WD of the center of gravity good balance design and the TT-01 chassis in the base, it finished in drift specification. The short spring and CVA oil damper setting super mini- to 4 wheel double wishbone suspension. You held down drive loss as a full bearing specification, loaded スポーツチƒ…ーンモーター, equipped also the aluminum motor heat sink. Furthermore, as for the tire the rubber the drift private type which combines the special resin to the base. Adopt individual cross section, give the moderate grip drift travelling is possible.

< Basic specifications >– Total length 449mm – full-width 185mm – the full-width (the mirror includes) 195mm – the wheel base 257mm – private drift tire width/diameter = FR 26/63mm – frame = bathtub type – drive system = vertical ranging motor & shaft drive full-time 4WD – also diff. gear = front and back 3 bevels – steering wheel = 3 divided tie rod systems – the suspension = 4 wheel double wishbone – damper = CVA oil damper super mini- – gear ratio = 8.35: 1 – Motor = RS540  – full bearing specification – speed controller = Tamiya TEU-101BK attachment

Source : Tamiya

This entry was posted in Tamiya. Bookmark the permalink.