Serpent – New items

Tool Ride height droop gauge

1466.jpg

All in one ride height and droop gauge tool.

1466a.jpg

Serpent is pleased to present this all-new ride height and droop gauge for use on all circuit based cars. Machined from a single block of aluminium, it has been orange anodised and lightened further with the addition of 3 holes in the body of the tool. This 2 in 1 gauge can measure both droop, when used in conjunction the new Serpent setup blocks, and can easily be used to measured the cars ride height by simply rotating it 90 degrees. The tool sports the new Serpent logo and can measure between 2mm and 10mm ride height and –2mm to 11mm droop.


Anti-Roll bar blade FR soft set

803204.jpg

Suitable for:
Serpent 720 1/10th scale 200mm
Serpent 720 07 1/10th scale 200mm
Serpent 960 07 1/8 scale 4WD

Newly available for the Serpent range of cars are these thin and therefore super soft front anti-roll bar blades. These new blades have the same hard setting as before but in the softest setting they are much softer providing even more steering and overall they allow a wider range of settings. The end of the shafts have also been changed and now have a new adjusting slot which enables you to easily see the setting of the anti-roll bar.

Fill plate LCG chassis brass
803207.jpg

Suitable for:
Serpent 720 1/10th scale 200mm
Serpent 720 07 1/10th scale 200mm
Chassis Plate 720 SPP Carbon
Chassis 4mm 720 LCG

New for the Serpent 720 is this brass plate for use in the optional LCG chassis plates (#803191, #803199). Made using very hard brass material, this plate provides more weight to the front of the car, helping to remove snap oversteer and allowing the car to corner faster and smoother. In addition to the improved cornering speeds the added weight mounted in the chassis helps prevent grip roll on high traction surfaces.

Source : Serpent

This entry was posted in Serpent. Bookmark the permalink.