Serpent – Setup Support Aluminum Blocks

Setup Support Aluminum Blocks

s1467.jpg

Serpent is pleased to introduce these handy setup blocks for use with our recently introduced ride height / droop gauge (#1466). Made from aluminium and anodised orange, these great looking 3-faced blocks raise your car by 10mm allowing you to measure and adjust your cars droop. Sold in a set of two, for the front and rear of your car, they come with the Serpent logo engraved on 2 of the blocks 3 sides, leaving you one side to place your own name. Suitable for all circuit based chassis’.

s1467a.jpg

Steering Blocks Evo2 720 – 0/1

s803212.jpg

For :
Serpent 720 1/10th scale 200mm
Serpent 720 07 1/10th scale 200mm

Available in 0 degree and 1 degree blocks

Pair of left and right composite wide off set steering blocks with 0/1 degrees kingpin angle.

New for the Serpent 720 are these Evo2 steering blocks, available in pairs with 0 and 1mm kingpin angle. These new blocks have 1mm more offset compared to the standard versions, which gives the car a more smooth steering style. The 0-degree blocks work well on medium traction surfaces while the 1-degree blocks work better on low to medium level traction surfaces. However if you swap the left and right 1-degree blocks, the car will then work better in high grip tracks, actually reducing the effects of grip roll, while at the same time giving the car smoother, more consistent, cornering.

Source : Serpent

This entry was posted in Serpent. Bookmark the permalink.