Tamiya – DT-02 MS

Official release by Tamiya Japan and available on Oct 27, 2007

Translation :

Option & the front residence color which pull out speed

The battery for travelling vertical ranging is done in center, adopting the chassis constitution which in center of gravity is superior low in weight balance e.g., the RC mechanic is loaded onto flat. The light running only of 2WD fully loaded the option part to the DT-02 chassis of charm, furthermore raised potential. High accuracy & high quality after grinding processing inside the aluminum make cylinder フッソコート processing, as for the oil damper which uses the resin for also the piston equipment of attention. Coupled with the hard turn buckle shaft, delicate suspension setting is possible. Drive system makes full ball bearing specification, also adjustment of effectiveness the possible ball diff., equipping the universal shaft which actualizes smooth power transmission in addition to the limited slip effect. It raises also drive efficiency. Furthermore, the polycarbonate make body and the marking sticker which is finished in the color of the residence player before TRF setting. It is the limited kit where completeness equipment and the color ring scratch combative spirit and raise.

Main equipment part
– Aluminum make oil damper
– white collar worker spring
– ball diff.
– universal shaft
– turn buckle shaft
– aluminum motor heat sink (blue alumite)
– full ball bearing

Oil damper
High accuracy & high quality after grinding processing inside the aluminum make cylinder フッソコート processing, using the フ ッ Soviet resin for also the piston.

Ball diff.

Showing the limited slip effect, to raise traction, also adjustment of effectiveness is possible.

Aluminum heat sink

Letting escape the heat of the motor effectively, preventing powering down with heat.

Basic specifications
– Total length 384mm, full-width 248mm and total height 135mm
– wheel base 260mm
– tread F: 216mm R: 206mm
– Drive system = rear motor rear wheel drive
– suspension: 4 wheel double wishbone
– gear ratio: 9.28 : 1

Source : Tamiya

This entry was posted in Tamiya. Bookmark the permalink.