Tamiya Japan – Nismo Coppermix SILVIA TB-02

49486logo.gif

49486top.jpg

49486terms.jpg

Available Feb 23, 2008

Translation :

The Drift is bright by light lighting

A lot of tune-up parts including the super-kappa mix clutch that surely catches the power of the high power engine and pursues easiness to treat are installed. It is an assembly kit of the electric radio control car that reproduces Nismo COPPERMIX Silvia that Nismo that took charge of motor sports of Nissan finished up by 1/10 scales. Being able to enjoy the drift running easily like the name is a charm. The body that reproduced a stylish form in the round is made of the polycarbonate. A gay marking was prepared in the sticker. In addition, two headlight lights (white) and two rear light lights (red) can be lit by equipping normally high luminance LED.

49486photo1.jpg

The FRONT light: High luminance LED is set in the low beam part of the light case where the plating processing is done. The flash of the white that blue that imaged HID of a real car drove is vivid.

49486photo2.jpg

Tail lamp: As for tail lamp clear lens pitch. Setting LED of the lead-lead to the case which same as the front it was plated was processed. The tail lamp of red lights up usual.

TB-02 chassis adoption of the shaft 4WD which equips the drift tire

As for the chassis the high performance adopting TB-02 of shaft drive 4WD. As the resin make bathtub frame is finished slimly to the extremity, prevents the interference of the road surface with the roll, optimizing center of gravity balance. The aluminum make propeller shaft, the front and back ball diff., completeness equipment such as upper arm and High torque servo saver which use the turn buckle shaft is charm. Furthermore, setting the super drift tire of the resin make which drift control is easy to do. There is no performance change with heat and wear almost, also height of durability is the point.

49486chassis.jpg

Specification

  •  Total length 444mm, full-width 187mm and total height 130mm
  •  the wheel base 257mm
  •  drift tire width/diameter = FR 26/63mm
  •  frame = bathtub type
  •  drive system = vertical ranging motor & shaft drive full-time 4WD
  •  diff. gear system F/R the = ball diff.
  •  the steering wheel tie rod =3 division
  •  suspension F/R the = double wishbone
  •  the damper =F/R the CVA damper super mini-
  •  gear ratio =7.94:1
  •  motor = RS540 type
  •  speed controller = ESC specification (selling separately)

Source : Tamiya

This entry was posted in Tamiya. Bookmark the permalink.