Tamiya Japan – Fairlady Z Version Nismo – TT01 Type-E

58402logo300.gif

58402spec.jpg

58402top550.jpg

Available Mar 29, 2008

The form polished at the racing speed is power

It is an electric radio control car assembly kit of version NISMO added as a top model of running in fair lady Z who installs V type 3.5 liter six cylinder engine that demonstrates the receiving 313 horsepower in January, 2007 as for the minor change of second. The reproduced body is made of the polycarbonate to enough actually feeling as for the aerodynamic form that NISMO that took charge of the race section of Nissan Motor finished up. The door mirror and Riyaspoirar tighten the form as another parts. In addition, the light case before and after is prepared with the plating parts. It can enjoy the light lighting two headlight lights and two rear light lights by equipping normally Tamiya LED light unit (TLU-01). Moreover, the rear light is imaging untouched finish of a real car that arranges two or more LED.


Shaft 4WD and TT-01 TYPE-E that improves running further are adopted

The chassis is TT-01 TYPE-E of length putting motor shaft drive 4WD. The upper deck and the gear cover made of fiberglass reinforced nylon resin were secured for the mainframe of the bathtub type, and it equipped and a high chassis rigidity was secured. The steering wheel system is a type of movement that play is few and smooth. divide into three. The characteristic of control is demonstrated together with equipped Defgiya etc. low center of gravity, the good balance design, four-wheel double wishbone suspension, and back and forth. Moreover, the number of parts is reduced, easiness to assemble is valued, and the body composition with a little part where the setting is necessary that treats easily is a charm. Of course, optional option parts are built in and the performance improvement is also possible.

58402chassis.gif

584021.jpg

Upright
The improvement lights in the back and forth are parts only for TT-01 TYPE-E
that strength is high and Gata is few.

584022.jpg

Steering wheel
The steering wheel of the type divide into three uses the aluminum pipe for the post. Smooth movement with a little play is invented.

584023.jpg

Damper Stay
Damper Stay and the gear cover are special parts of another body structure. The damper installation point is set up in Damper stay. two places

584024.jpg

Upper deck
Upper deck made of fiberglass mixing nylon resin. The chassis rigidity is improved.

584025.jpg

Stand for the transponder that can be called necessaries of the race is installed in the
upper deck.

584026.jpg

Rear light
Rear light that faithfully reproduced forming real car. If optional 5mm in diameter of the LED light red is added, it becomes more real more finished.

Basic specifications

  • Total length 435mm, full-width 190mm and total height 140mm
  • the wheel base 257mm
  • tire width/diameter = FR 27/67mm
  • frame = bathtub type
  • drive system = vertical ranging motor & shaft drive full-time 4WD
  • diff. gear = front and back 3 bevels
  • steering wheel = 3 divided tie rod systems
  • the suspension = 4 wheel double wishbone
  • damper = front and back the friction
  • gear ratio = 8.35:1
  • motor = 540 types
  • speed controller = ESC specification

Improve Performance

54025.jpg

Item 54025 (OP.1025) – TT-01 Type-E Ball Bearing

54026.jpg

ITEM 54026 (OP.1026) – TT-01 aluminum propeller joint & shaft set

53800.jpg

Aluminum toe in rear upright (TT-01 TGS)

Source : Tamiya

This entry was posted in Tamiya and tagged , . Bookmark the permalink.