1/10 mini- chassis < [Genetic] > the DATSUN fair ready 240Z BRE edition kit

Available July 2008

Read the rest of this entry »

Principal equipment
* Carbon make chassis, upper brace, damper brace and lower brace, pivot bridge
* brush less motor corresponding motor mount
* 1/4″ The carbon rear shaft
* the carbon suspension arm (the independent suspension) the upper arm mount of 4 types of
* 0°, 5°, 10° and 15° * [derurin] it starts shaving, the pivot ball
* φ6.5 bulk oil damper & the natural FRP make T bar & the carbon rear shaft
* high accuracy film gate wheel
* EMB battery mount & Battery bracket & large diameter diff. ring
* FRP antenna & servo saber
* full ball bearing

Read the rest of this entry »

IB3800VR-1X 08 World Spec 5cell and 6 cell

The IB3800VR-1X 08 series is an additional lineup in the VELOCITY RACING BATTERY series to
boast of a preeminent agility.
Having given birth as a high voltage cell that boasts of intellect strongest Co. in a domestic
limitation is IB3800VR-1X 08.
We will deliver ultimate power to which VELOCITY RACING that did not permit compromising
turned on the latest technology.

Read the rest of this entry »

A brief coverage of teh 2008 Reedy Race of Champions from Roseville by KCRA

Source & View the Video from KCRA

After constant tests, we have futher changed some designs to make the car more competitive and easier to drive.  Mainly the front end, fuel tank, chassis, radio plate and numurous small parts are revised.  Though it’s not ready for production yet, but you can easily tell the car is getting better and better each day.  Below you are find the new version of our 1/8 gas onroad car.

Read the rest of this entry »

Modified A1

Read the rest of this entry »

Race report by Michal Bok

Round 2 of the Czech Republic Championship for 1/8 off-road and truggy was held on the weekend of May 17 & 18 at track of club 1.PTS Táborník near Mlada Boleslav. The track was very technical and flat until Saturday’s final. Free practice was on Friday for 3 hours. During the free practice there was a strong rainshower but it lasted only a little while. During my free practice (and also Martin Pater’s) our XRAY XB808 cars handled great. There were 66 drivers at the start of the race on Saturday, and during qualification the cars ran fast and hard.

Read the rest of this entry »

With more than 300 entries, the Hank Perry 240 is one of the most popular races in the North West, attracting top factory talent from many of the major manufacturers. Kyosho driver Taylor Peterson dominated the event, qualifying first in the Pro Buggy class with an Orion-powered Kyosho Inferno 777, and second in the Pro Truggy class with Kyosho Inferno ST-RR; also running the new Orion .21 engine.

Petersen battled closely with a couple of the front runners early in the buggy main, trading the lead during pit stops. Petersen finally took the lead for the last time on lap 35 and held it to the end of the 74 lap, 30-minute A-main. It’s worth noting that Petersen was leading for 62 of the 74 laps and he finished a lap up on second place.

The truggy main also started with some close racing with the early leaders, but it took a challenging turn when an poorly-placed hand by Petersen’s mechanic during the first fuel stop caused the engine to stall, knocking him back to fifth place and a full lap down. Petersen put his head down and charged as hard as possible to get back on the lead lap, and then passed the frontrunners again on lap 70 to take the race lead. Petersen pulled out more than a five second lead over the last five laps to seal the win in the Pro Truggy class. Petersen also took top honors in the 1/10 truck class. Petersen runs Werks fuel and KO Propo radio systems in all of his racing rigs.

Source : Kyosho

R/C Car legend and 14-time IFMAR World-Champion Masami Hirosaka has recently signed for Team NOSRAM!

An introduction of this driver may not be necessary due to his high status in the R/C industry. However, the 14 time world champion is known for his amazing skills on and off the track and also for his high level of perfectionism. For a driver like Masami, only the best possible equipment will do. Masami has chosen to use Team NOSRAM brushless motors and speed controls. This perfect combination will give him that important advantage over the competition!

Read the rest of this entry »

Source : HPI