HIROSAKA MATCHED HE4600UP

Translate from Japanese :

It is a lineup as for two grades (RUBY and Diamond) by the
collaboration with the mastering mechanic ‘Is it a width?’.
Six cells, five cells, and four cells are additionally released to the
usage.

As for the width or Mattid, here is different.
– It sells it with each cell soldered in the battery made of ROCHE bar.
The measurements are actually different from the data measured every one cell while united. The HIROSAKA MATCHED battery measures data with the cell united.
– The detailed data encloses it with all the batteries.
Data is measured in the condition similar to the state of running based on the actual combat experience of Cousacashi. It is assumed to be “MATCHED” that “TOTAL” and the Mattid condition of the performance of the battery and evaluates the point of each 100 point full marks.

Because the seal that simply writes the result of the management number, TOTAL, and MATCHED etc. is pasted to each battery, the performance of the battery can be confirmed at one view. (← photograph is an example of the reference. )

The detailed data is enclosed with all packing. It is told that the graph where almost the same line is drawn is genuine Mattidobattere without the lie.

– Battery made of ROCHE bar use
– HE4600UP 1.2V 4600mAh 6cell / 5cell / 4cell
– Is it Zappd & Mattid by width?

So that H-Energy battery is maintained and safe, good performance will be
maintained

There is a thing that there is a thing self-discharged, too and the voltage has lowered
for the new article of Mitsuru, too.
5A? from it. first charge itPlease use it after doing the break Inn discharged by about
10A.

Please charge it by 5A or less. (The temperature cutting method is recommended. )
Please reduce a set value of the peak as much as possible though it is possible to charge unquestionably even by the peak cutting method. (lowest value that can be set with charger)However, it is necessary to note it because there is a thing cut while charging it, too, when the setting is too low. In this case, please raise a set value a little.

When 50℃ is exceeded while charging it, the battery might be damaged.
Please note becoming 45℃ or less at the temperature when the charge ends. (The temperature rises after the charge stops. )Please stop charging once while charging it when it rises in temperature too much, and charge it again after cooling the battery. The performance doesn’t change.

The temperature of the battery when it runs must start at 40℃ or less (level that
touches by the hand and is not hot).

Please preserve it while charged after use. (The full charge is not cared by 2000mA
or more either. )Please charge it sometimes (place once every two weeks) when it is
not used for a long term (about two months or more).

There is a thing that the battery is damaged, too, when putting it for a long
term with electricity discharged.

Please discharge electricity after first doing charge (About 1000mA) charge once when using it again (The single cell electrical discharge is preferable) and discharge electricity by 5A or less when there is no single cell electrical discharge machine. (The day before is acceptable. )After that, this charge is done.

– Use method large current charge that gives battery big damage and
charge with 5A or more by large current.
Use of temperature of thing (use etc. such as Uormar) battery that
turns up the heat too much while charging it from height (40℃ or
more).
The battery ….empty.. drinking.. preserves it for a long term in
Joutai.

品番
品  名
希望小売価格
PJ-H028HE
HIROSAKA MATCHED HE4600UP RUBY 6 cell ルビー 6セル
\9,400
PJ-H029HE
HIROSAKA MATCHED HE4600UP Diamond 6 cell 6セル
\11,000
PJ-H030HE
HIROSAKA MATCHED HE4600UP RUBY 5 cell ルビー 5セル
\8,100
PJ-H031HE
HIROSAKA MATCHED HE4600UP Diamond 6 cell ダイヤ 5セル
\9,500
PJ-H032HE
HIROSAKA MATCHED HE4600UP RUBY 5 cell ルビー 4セル
\7,000
PJ-H033HE
HIROSAKA MATCHED HE4600UP Diamond 6 cell ダイヤ 4セル
\8,200

Source : Powers

This entry was posted in RCeasy News and tagged . Bookmark the permalink.