Available Nov 29, 2008

Sharp running of direct drive charm
It is the assembly kit of the electromotive RC car where the motor pinion drives the spur gear directly, can enjoy the sharp running only of rear [dairekutodoraibu]. The chassis constitution which combines the upper deck of half type to FRP make [rowadetsuki]. The front left and right independence of [kingupinkoiru] spring system, the FRP make T bar present appearance it controls the rear with the friction plate and the coil spring. The constitution which applies the load on the rear wheel which loads 540 type motors onto the height adjustment type body, as for the 7.2V battery for travelling loading onto the rear approaching, becomes the driving wheel. In addition, standing upside down mounting steering wheel servo, isometric conversion the tie rod left and right. The steering wheel quality which does not have [kuse] is produced. It is easy to assemble with simple constitution, due to the lightweight body the sharp running and long haul travelling it can enjoy. Polycarbonate make body, front and back wing attachment.

Main equipment part
FRP make half double deck ●FRP make T bar　- Ball diff.　- Formula lightweight diff. joint　- Formula height adjustment body　- Formula [riyasasuborumaunto]　- Front and back sponge tire　- Full bearing specification ●540 type motor attachment

As for body height adjustment type. In addition, standard equipping the lightweight diff. joint, it actualizes sharp startup acceleration with the light weight conversion of the rotary part.

The coil spring was equipped in the king pin of upright, adopting the front suspension of left and right independence type.

The FRP make T bar present appearance the friction damper and the rear suspension which is controlled with the coil spring.

Basic specifications
- Chassis length =330mm (wing less)　- Chassis width =200mm　- Tread =F: 170mm R: 160mm　- Motor =540 type – Drive system = rear wheel direct drive – Diff. gear = ball diff. – Steering wheel tie rod = isometric 2 divisions – Suspension = front [kingupinkoiru] independence, rear T bar rigidity　- Gear ratio =3.7: 1 – Tire width/diameter =F: 30/60mm R: 40/64mm　- Controller =ESC specification

Source : Tamiya

Share on Facebook

This entry was posted on Thursday, November 20th, 2008 at 7:16 am and is filed under Tamiya. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.