Available : Jun 27, 2009
Translation :
FF happiness pursuit
It is the assembly chassis kit which brushes up M chassis of popularity with the running which brisks. As the resin make semi monocoque frame takes a second look the helicopter loading site of the RC mechanic, et. al optimizes weight distribution also center of gravity conversion actualizes low. The front bumper made the form where the skid effect is high. Modifying 4 wheel double wishbone suspension the dimension the front. 4 you install the CVA oil damper of clear specification, the front to lay down set somewhat tend. In addition preparing the white spring of hardness of 3 kinds, it expands the width of setting. Furthermore, adopting 3 divided wipers for the steering wheel, it cancelled bump in, improved the stability at the time of cornering. In addition, to be suitable the OP part of aluminum servo horn and aluminum rear upright etc standard was equipped in the name of PRO.
Body selection is delightful in the wheel base of 3 kinds
Is low as for the center of gravity which held down weight things such as the battery and the motor and furthermore the RC mechanic etc within height of the tire chassis, by the fact that the part of the rear suspension part is rearranged the wheel base of 3 kinds of 210mm 225mm 239mm selective possibility. It can load the body for the various M-03 chassis and width of selection spreads. Tread pattern real the 60D radial tire was installed to 11 these spoke wheels of the white collar worker.
Adopting 3 divided wipers steering wheel, rationalizing the behavior change when suspension movable. Stability at the time of cornering is raised.
The RC mechanic loads onto the body rear section. Steering wheel servo on the body centerline, it is the constitution which is superior even in the maintainability which arranges receiver and ESC on the left and right.
As the battery is held securely, the resin make holder which prevents the fact that the battery is hurt with contact with the road surface. It corresponds to also the LF battery.
Main equipment part
●M-03R aluminum rear upright – Short spring for aluminum horn ●CVA [danpasupamini] ●TRF damper of high torque servo saber (software/medium/hard) ●1150 bearing ●850 bearing – Aluminum pyro ball (blue) – Aluminum 5mm ball nut (blue) ●2.0mm setting spacer (blue) ●3.0mm setting spacer (blue) ●4mm aluminum flange lock nut (blue) – High torque servo saber
Basic specifications
- Chassis length: 299mm (at the time of wheel based 239mm) chassis width: 165mm - 3 kinds of wheel base 210mm 225mm 239mm selective possibility - Also tread front and back 138mm - Drive system = [hurontomidoshitsupumota] nosewheel drive - Diff. gear system =3 bevel - Steering wheel tie rod =3 division - Suspension F/R = double wishbone - Damper also =F/R CVA [oirudanpasupamini] - Gear ratio =5.8: 1 - Tire width/diameter also =FR 25/59mm - Speed controller =ESC specification (selling separately)
Source : Tamiya
Entries (RSS)